|
The Warrigal I and II were Australian aircraft designed by Squadron Leader Lawrence James Wackett and built by the Experimental Section of the Royal Australian Air Force (RAAF) at Randwick, New South Wales, during the late 1920s. They were both single-engined, two-seat biplanes of mixed wood and metal construction. The Warrigal I was the first aircraft designed and built in Australia to an official RAAF specification.〔Meggs 2009, p297〕 ==Development== The Warrigal (an Aboriginal word meaning "wild" or "untamed") I aircraft was designed to meet Air Board specification AC34 for an advanced training aircraft suitable to replace the ageing RAAF Avro 504K fleet. The aircraft was not only required to carry out flight training, but also training in aerial combat, bombing, wireless communication, aerial photography and observation. A mock-up was completed in February 1926 and construction was commenced shortly after. Wackett expected that construction would take around 6 months. However work on the Widgeon II and spare parts for RAAF No. 1 Air Depot delayed completion until mid-September 1928. A further two-month delay ensued when it was discovered that the centre of gravity was not as designed and several items of equipment needed to be relocated to obtain the correct balance.〔Meggs 2009, p295〕 Wackett made the first flight in the Warrigal I on 4 December 1928 at RAAF Richmond. A series of extensive trials covering all the intended roles was carried out by No. 1 Flying Training School. These showed that performance was lower than the designer's predicted figures and, while it met many of the requirements in specification AC34, the Warrigal I had handling problems which made it unsuitable for use as a trainer. Wackett was dismissive of the final report on the trials, claiming that the results were qualitative only, lacking a "recognised or rational system of observation or measurement". He claimed that the improved Warrigal II design would resolve issues raised in the report.〔Meggs 2009, p297〕 The Warrigal II was designed to meet an RAAF specification for an Army co-operation aircraft to replace the aging fleet of DH.9 aircraft,〔Coulthard-Clark 1991, p267〕 and was equipped with a more powerful (and heavier) Jaguar engine which resulted in a shorter nose to keep the centre of gravity in the correct range. Drawings for the Warrigal II were submitted to the Air Board in August 1929 with the explanation that all defects found in the first aircraft had been rectified and that construction was well underway. This led to questions by the Auditor-General since there was no written authority for the RAAF Experimental Section to commence construction of a second aircraft. However the situation was rectified with the correct authorisation coming from the Minister for Defence in January 1930〔Coulthard-Clark 1991, p269〕 by which time the aircraft was almost complete. The closure of the RAAF Experimental Section at Randwick which had been recommended by the Salmond Report was delayed until 30 March 1930 so the aircraft could be completed. The Warrigal II was moved to RAAF Richmond in April 1930 for final assembly and rigging. The first flight was delayed by the requirement to re-check the design stress calculations following the crash of the Widgeon II seaplane which had also been designed by Wackett. The checks were carried out by the Director of Technical Services, Squadron Leader H.C. Harrison and were found to be satisfactory. The first flight of the Warrigal II was carried out by Flying Officer R.H. Simms on 7 July 1930. Shortly after this it suffered a hard landing at Mascot airport and required repairs to the undercarriage and wings. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Wackett Warrigal」の詳細全文を読む スポンサード リンク
|